Sprung Stand High Levels

This operating high level switch stand is patterned after the
type used by the Milwaukee Road and many other railroads. The
stand is made of Delrin and is supplied with ABS targets.

Look at these features:

Choice of 5 different end connectors for easy connection to most
turnout.
A connector receptacle on either end of the slide bar permits
selective mounting positions for the most favorable handle swing.

A stop and lock at both ends of the throw.
180 degrees handle rotation turns the target 90 degrees through
small gears.
Six paintable, bondable ABS targets - including a lantern and
square/diamond - select your favorites. Packaged separately for
easy storage until needed. Modeler must assemble.
Enough .025" dia (#22 wire) rod for an eight foot high target.
Cut to your desired length.
Provisions made so targets can be made to operate from below the
table on electrically controlled turnouts. Modeler must
fabricate own linkage.
Like our ground throws, the high levels are available either with
the rigid or the internally sprung slide bar. In the 204S,
internal stainless steel springs will take up the overtravel and
maintain tension to hold the points against the stock rails of
the turnout. The internal springs make the model 204S easy to
mount to any turnout.

HO & S Scale with .190 travel